Nissan Juke Service and Repair Manual : CAN communication circuit

Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.

Each control unit transmits/receives data but selectively reads required data only.

Component Function Check

1.CHECK CAN COMMUNICATION CIRCUIT

1. Turn ignition switch ON.

2. Check DTC.

Is DTC detected? YES >> EC-1014, "Diagnosis Procedure" NO >> INSPECTION END.

Diagnosis Procedure

Go to LAN-17, "Trouble Diagnosis Flow Chart".

    ASCD steering switch
    Component Function Check 1.CHECK ASCD STEERING SWITCH FUNCTION 1. Turn ignition switch ON. 2. Check the voltage between ECM harness connector terminals under the following conditions. Is the i ...

    Cooling fan
    Diagnosis Procedure 1.CHECK GROUND CONNECTION 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground Inspection in GI-44, "Circuit Inspection". Is the inspectio ...

    Other materials:

    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
    The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is include ...

    Handling precaution
    Nissan Dynamic Control System • The engine torque, engine power, boost, and instantaneous fuel consumption are provided for information purposes only. They are not intended to prompt the driver to adjust driving style. The readings may be slightly delayed relative to the actual vehicle behavi ...

    Power supply and ground circuit
    Diagnosis Procedure 1.CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible links are not blown. Is the fuse fusing? YES >> Replace the blown fuse or fusible link after repairing the affected circuit if a fuse or fusible link is blown. NO >> GO TO 2. ...