Nissan Juke Service and Repair Manual : Buzzer (combination meter)

Component Function Check

1.CHECK FUNCTION

1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.

2. Select “INSIDE BUZZER” in “ACTIVE TEST” mode.

3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?


Is the inspection result normal? Yes >> Buzzer (combination meter) is OK.

No >> Refer to DLK-73, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK METER BUZZER CIRCUIT

Refer to WCS-40, "Component Function Check".

Is the inspection result normal? Yes >> GO TO 2.

No >> Repair or replace the malfunctioning parts.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> INSPECTION END

    Back door request switch
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “REQ SW-BD/TR” in “DATA MONITOR” mode. 3. Check that the function operates normally acco ...

    Door lock actuator
    Driver side : Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK” in “ACTIVE TEST” mode. 3. Check that the function operates normally ...

    Other materials:

    DTC/Circuit diagnosis
    POSITION SWITCH BACK-UP LAMP SWITCH : Component Inspection 1.CHECK BACK-UP LAMP SWITCH 1. Disconnect position switch connector. Refer to TM-24, "Removal and Installation". 2. Check continuity between position switch terminals. Is the inspection result normal? YES >> INSPE ...

    PTC heater control unit connection recognition signal circuit
    Diagnosis Procedure 1.CHECK PTC HEATER CONTROL UNIT CONNECTION RECOGNITION SIGNAL 1. Turn ignition switch ON. 2. Check voltage between combination meter harness connector and ground. Is the inspection result normal? YES >> INSPECTION END NO >> GO TO 2. 2.CHECK PTC HEATER CONTR ...

    Rear fog lamp circuit
    Component Function Check 1.CHECK REAR FOG LAMP OPERATION CONSULT-III ACTIVE TEST 1. Select “RR FOG LAMP” of BCM (HEAD LAMP) active test item. 2. With operating the test items, check that the rear fog lamp is turned ON. On : Rear fog lamp ON Off : Rear fog lamp OFF Is the inspection result nor ...