Nissan Juke Service and Repair Manual : Brake warning lamp

Component Function Check

1.CHECK BRAKE WARNING LAMP FUNCTION (1)

Check that brake warning lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON.

CAUTION:
Never start engine.

Is the inspection result normal? YES >> GO TO 2.

NO >> Proceed to BRC-70, "Diagnosis Procedure".

2.CHECK BRAKE WARNING LAMP FUNCTION (2)

Check that brake warning lamp in combination meter turns ON/OFF when parking brake is operated.

NOTE

:

Brake warning lamp turns ON when parking brake is operated (when parking brake switch is ON).

Is the inspection result normal? YES >> GO TO 3.

NO >> Check parking brake switch system. Refer to BRC-70, "Diagnosis Procedure".

3.CHECK BRAKE WARNING LAMP FUNCTION (3)

Check that brake warning lamp in combination meter turns ON/OFF when brake fluid level switch is operated while brake fluid level in reservoir tank is with the specified level.

NOTE

:
Brake warning lamp turns ON when brake fluid is less than the specified level (when brake fluid level switch is ON).

Is the inspection result normal? YES >> INSPECTION END

NO >> Check brake fluid level switch system. Refer to BRC-70, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT

Perform the trouble diagnosis for ABS actuator and electric unit (control unit) power supply and ground circuit.

Refer to BRC-64, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace error-detected parts.

2.PERFORM THE SELF-DIAGNOSIS

Perform self-diagnosis for “ABS”.With CONSULT-III.


Perform self-diagnosis for “ABS”.

Is any DTC detected? YES >> Check the DTC. Refer to BRC-31, "DTC Index".

NO >> GO TO 3.

3.CHECK COMBINATION METER

Check combination meter. Refer to MWI-23, "CONSULT-III Function".

Is the inspection result normal? YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC-90, "Removal and Installation".

NO >> Repair or replace combination meter. Refer to MWI-69, "Removal and Installation".

    ABS warning lamp
    Component Function Check 1.CHECK ABS WARNING LAMP FUNCTION Check that ABS warning lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON. CAUTION: Never st ...

    Other materials:

    Excessive operation frequency
    Description ABS function and EBD function operates in excessive operation frequency. Diagnosis Procedure 1.CHECK BRAKING FORCE Check brake force using a brake tester. Is the inspection result normal? YES >> GO TO 2. NO >> Check brake system. 2.CHECK FRONT AND REAR AXLE Che ...

    B1186, B1187, B1188, B1189, B1190, B1191 diagnosis sensor unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

    P1701 TCM
    Description When the power supply to the TCM is cut OFF, for example because the battery is removed, and the self-diagnosis memory function stops, malfunction is detected. NOTE: Since “P1701” will be indicated when replacing TCM, perform diagnosis after erasing “SELF-DIAG RESULTS” DTC Lo ...