Nissan Juke Service and Repair Manual : Brake booster

Inspection

OPERATION

Depress the brake pedal several times at 5-second intervals with the engine stopped. Start the engine with the brake pedal fully depressed. Check that the clearance between brake pedal and dash lower panel decreases.

NOTE: A slight impact with a small click may be felt on the pedal when the brake pedal is fully depressed. This is a normal phenomenon due to the brake system operation.

AIR TIGHT

1. Run the engine at idle for 1 minute to apply vacuum to the brake booster, and stop the engine.

2. Depress the brake pedal several times at 5-second intervals until the accumulated vacuum is released to atmospheric pressure. Check that the clearance between brake pedal and dash lower panel gradually increases each time the brake pedal is depressed when performing this operation.

3. Depress the brake pedal with the engine running. Then stop the engine while holding down the brake pedal. Check that the brake pedal stroke does not change after holding down the brake pedal for 30 seconds or more.

    Brake master cylinder
    Inspection FLUID LEAK Check for brake fluid leakage from the master cylinder mounting face, reservoir tank mounting face and brake tube connections. ...

    Front disc brake
    Brake pad : Inspection and Adjustment INSPECTION Check brake pad wear thickness from an inspection hole on cylinder body. Check using a scale if necessary. Wear thickness : Refer to BR-71, "F ...

    Other materials:

    Camera image signal circuit
    Description • The NAVI control unit supplies power to the rear view camera when receiving a reverse signal. • The rear view camera transmits camera images to the NAVI control unit when power is supplied from the NAVI control unit. Diagnosis Procedure 1.CHECK CONTINUITY CAMERA POWER SUPPLY C ...

    System
    POWER WINDOW SYSTEM POWER WINDOW SYSTEM : System Diagram POWER WINDOW SYSTEM : System Description • Power window system is activated by power window switch when ignition switch turns ON. • Power window main switch opens/closes all door glass. • Front and rear power window switch opens/close ...

    System
    System Description • The system switches fluid pressure of each brake caliper to increase, to hold or to decrease according to signals from control unit in ABS actuator and electric unit (control unit). This control system is applied to ABS function and EBD function. • Fail-safe function is ...