Nissan Juke Service and Repair Manual : Both side front fog lamps are not turned on

Description

The front fog lamps are not turned ON in any condition.

Diagnosis Procedure

1.CHECK FUSE

Check that the following fuse is fusing.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the applicable circuit. And then replace the fuse.

2.COMBINATION SWITCH INSPECTION

Check combination switch. Refer to BCS-92, "Symptom Table".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning part.

3.CHECK FRONT FOG LAMP REQUEST SIGNAL INPUT

1. Select “FR FOG REQ” of IPDM E/R data monitor item.CONSULT-III DATA MONITOR


1. Select “FR FOG REQ” of IPDM E/R data monitor item.

2. With operating the front fog lamp switch, check the monitor status.

Is the inspection result normal?


Is the inspection result normal? YES >> Replace IPDM E/R.

NO >> Replace BCM. Refer to BCS-93, "Removal and Installation" (with Intelligent Key), BCS-161, "Removal and Installation" (without Intelligent Key).

    Parking, license plate and tail lamps are not turned on
    Without daytime running light system WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Description The parking, license plate, tail lamps and each illumination are not turned ON in any condition. WITHOUT DA ...

    Other materials:

    Rear fog lamp circuit
    Component Function Check 1.CHECK REAR FOG LAMP OPERATION CONSULT-III ACTIVE TEST 1. Select “RR FOG LAMP” of BCM (HEAD LAMP) active test item. 2. With operating the test items, check that the rear fog lamp is turned ON. On : Rear fog lamp ON Off : Rear fog lamp OFF Is the inspection result nor ...

    Side turn signal lamp
    Exploded View 1. Side turn signal lamp bulb 2. Side turn signal lamp hous Removal and Installation CAUTION: Disconnect battery negative terminal or remove the fuse. REMOVAL 1. Remove the side turn signal lamp in numerical order shown in the figure. 2. Rotate the bulb socket counterclockw ...

    Loading tips
    •  The GVW must not exceed GVWR or GAWR as specified on the F.M.V.S.S./ C.M.V.S.S. certification label. • Do not load the front and rear axle to the GAWR. Doing so will exceed the GVWR. WARNING •  Properly secure all cargo with ropes or straps to help prevent it from sliding or shif ...