Nissan Juke Service and Repair Manual : Body component parts
Underbody Component Parts (2WD Models)
: Both sided anti-corrosive
precoated steel sections
: High strength steel (HSS)
sections
: Both sided anti-corrosive steel
and HSS sections
NOTE
:
• For the parts without a number described in the figure, it is supplied only
with the assembly part that the part is included with.
• Tensile strength column shows the largest strength value of a part in the component part.
Underbody Component Parts (4WD Models)
: Both sided anti-corrosive
precoated steel sections
: High strength steel (HSS)
sections
: Both sided anti-corrosive steel
and HSS sections
NOTE
:
• For the parts without a number described in the figure, it is supplied only
with the assembly part that the part is included with.
• Tensile strength column shows the largest strength value of a part in the component part.
Body Component Parts (2WD Models)
A. Right side
: Both sided anti-corrosive
precoated steel sections
: High strength steel (HSS)
sections
: Both sided anti-corrosive steel
and HSS sections
NOTE
:
• For the parts without a number described in the figure, it is supplied only
with the assembly part that the part is included with.
• Tensile strength column shows the largest strength value of a part in the component part.
Body Component Parts (4WD Models)
A. Right side
: Both sided anti-corrosive
precoated steel sections
: High strength steel (HSS)
sections
: Both sided anti-corrosive steel
and HSS sections
NOTE
:
• For the parts without a number described in the figure, it is supplied only
with the assembly part that the part is included with.
• Tensile strength column shows the largest strength value of a part in the component part
Repairing material
Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foa ...Other materials:
Back door opener switch
Component Function Check
1.CHECK FUNCTION
1. Select “TRUNK” of “BCM” using CONSULT-III.
2. Select “TRNK OPNR SW” in “DATA MONITOR” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Back door opener switch ...
Air cleaner filter
Exploded View
1. Turbocharger air inlet pipe
2. Clamp
3. Air duct (suction)
4. Air mass flow sensor
5. O-ring
6. Air duct (inlet)
7. Grommet
8. Air cleaner case
9. Air cleaner filter
10. Cover
11. Holder
A. : To turbocharger
: Vehicle front
: N·m (kg-m, in-lb)
: Always replac ...
Door lock and unlock switch
Component Function Check
1.CHECK FUNCTION
1. Select “DOOR LOCK” of “BCM” using CONSULT-III.
2. Select “CDL LOCK SW”, “CDL UNLOCK SW” in “DATA MONITOR” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Doo ...