Nissan Juke Service and Repair Manual : Blower fan resistor
Exploded View
1. Heater unit assembly
2. Fan control amp.*1
3. Blower fan resistor*2
4. Blower motor
5. Blower motor cover
• *1: Automatic air conditioner • *2: Manual air conditioner or Manual heater
Removal and Installation
REMOVAL
1. Remove instrument panel assembly. Refer to IP-13, "Removal and Installation".
2. Disconnect blower fan resistor connector.
3. Remove fixing screws (A), and then remove blower fan resistor (1).
INSTALLATION Install in the reverse order of removal.
Heater control
Exploded View 1. Intake door cable 2. Air mix door cable 3. Mode door cable 4. Heater control 5. Intake door lever knob A. To intake door link B. To air mix door link C. To mode door li ...Door cable
Exploded View LEFT SIDE 1. Heater unit assembly 2. Intake door lever 3. Intake door link 4. Intake door cable 5. Air mix door cable 6. Air mix door link 7. Air mix door rod 8. Lower ai ...Other materials:
Handling precaution
Nissan Dynamic Control System
• The engine torque, engine power, boost, and instantaneous fuel consumption
are provided for information
purposes only. They are not intended to prompt the driver to adjust driving
style. The readings may be
slightly delayed relative to the actual vehicle behavi ...
Cylinder head
Exploded View
1. Camshaft sprocket
2. Cylinder head suspended bracket
3. Valve lifter
4. Valve rotator
5. Valve spring retainer
6. Valve spring
7. Exhaust valve
8. Intake valve
9. Valve collet
10. Cap
11. Rear engine slinger
12. Cylinder head gasket
13. Cylinder head
14. Cam ...
Operation inspection
Work Procedure
The purpose of the operational check is to check that the individual system
operates normally.
Check condition : Engine running at normal operating temperature.
1.CHECK MEMORY FUNCTION
1. Set temperature to 30°C by operating the temperature control dial.
2. Press OFF switch.
3 ...