Nissan Juke Service and Repair Manual : BCM (body control module)
Removal and Installation
CAUTION:
Before replacing BCM, perform “READ CONFIGURATION” to save or print current
vehicle specification.
Refer to BCS-150, "Description".
REMOVAL (RHD MODELS)
1. Remove glove box assembly. Refer to IP-13, "Removal and Installation".
2. Remove harness clip.
3. Remove BCM mounting screws.
4. Remove BCM and disconnect the connectors.
5. Remove relays and relay mounting bracket from BCM.
REMOVAL (LHD MODELS)
1. Remove instrument lower panel. Refer to IP-13, "Removal and Installation".
2. Remove harness clip.
3. Remove BCM mounting screws.
4. Remove BCM and disconnect the connectors.
5. Remove relays and relay mounting bracket from BCM.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
• Be sure to perform “WRITE CONFIGURATION” when replacing BCM.
• Be sure to perform the system initialization (NATS) when replacing BCM. Refer to BCS-151, "Work Procedure".
Combination switch
Exploded View 1. Combination switch 2. Combination switch connector Removal and Installation REMOVAL 1. Remove steering column cover. Refer to IP-13, "Removal and Installation". 2 ...Other materials:
P0107, P0108 atmospheric pressure
sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swi ...
Power supply and ground circuit
Diagnosis Procedure
1.CHECK FUSES AND FUSIBLE LINK
Check that the following fuses and fusible link are not fusing.
Is the fuse fusing?
YES >> Replace the blown fuse or fusible link after repairing the affected
circuit if a fuse or fusible link is
blown.
NO >> GO TO 2.
2.CH ...
Diagnosis system (BCM) (without intelligent key system)
common item
Common item : consult-III Function (BCM - common item)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for ...