Nissan Juke Service and Repair Manual : Battery
Exploded View
1 : Battery fix frame
:N·m (kg-m, in-lb)
Removal and Installation
REMOVAL
1. Disconnect the battery cable from the negative terminal.
CAUTION:
When disconnecting, disconnect the battery cable from the negative terminal
first.
2. Remove cover of battery positive terminal.
3. Disconnect the battery cable from the positive terminal.
4. Remove battery fix frame mounting nuts and battery fix frame.
5. Remove battery.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
To install the battery, carefully read the following instructions.
• When connecting, connect the battery cable to the positive terminal first.
• After connecting battery cables, ensure that they are tightly clamped to battery terminals for good contact.
• Check battery terminal for poor connection caused by corrosion.
Reset electronic systems as necessary. Refer to GI-54, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Required Procedure After Battery Disconnection".
Battery terminal with fusible link
Exploded View 1 : Battery terminal with fusible link 2 : Harness connector : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Disconnect the battery cable from the negative terminal. 2. ...Other materials:
Seat belt buckle switch signal circuit (driver side)
Component Function Check
1.CHECK COMBINATION METER INPUT SIGNAL
Select the “Data Monitor” for the “METER/M&A” and check the “BUCKLE SW”
monitor value.
BUCKLE SW
When driver seat belt is fastened : Off
When driver seat belt is unfastened : On
>> INSPECTION END
Diagnosis Procedure
...
P0226 APP sensor
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK GROUND CONNECTIONS
1. Turn ignition switch OFF.
2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit
Inspection".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or ...
Normal operating condition
Description
FRONT WIPER MOTOR PROTECTION FUNCTION
• IPDM E/R may stop the front wiper to protect the front wiper motor if any
obstruction (operation resistance)
such as a large amount of snow is detected during the front wiper operation.
• At that time turn OFF the front wiper and remove the f ...