Nissan Juke Service and Repair Manual : Basic inspection
- Diagnosis and repair workflow
- Basic inspection
- Additional service when replacing ECM
- EGR volume control valve closed position learning
- Throttle valve closed position learning
- Service regeneration
- DPF (diesel particulate filter) data clear
Wiring diagram
Engine control system Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Conne ...Diagnosis and repair workflow
Work Flow OVERALL SEQUENCE • Malfunctions are declared as either present or stored (depending on whether they appeared in a certain context and have disappeared since, or whether they remain pr ...Other materials:
Rear-facing child restraint installation using LATCH
Refer to all Warnings and Cautions in the “Child safety” and “Child restraints”
sections before installing a child restraint.
Follow these steps to install a rear-facing child restraint using the LATCH system:
1. Position the child restraint on the seat.
Always follow the child restraint manufa ...
Precaution Necessary for Steering Wheel Rotation
after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the push-button
ignition switch to the LOCK position,
then disconnect both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Alw ...
P160C ECM
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Erase DTC.
3. Turn ignition switch OFF and wait for 20 seconds.
4. Turn ignition switch ON and perform the self-diagnosis.
Is the DTC P160C displayed again?
YES >> GO TO 2.
NO &g ...