Nissan Juke Service and Repair Manual : Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
DESCRIPTION OF TROUBLE DIAGNOSIS FLOWCHART
DETAILS OF TROUBLE DIAGNOSIS FLOWCHART
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurs.
>> GO TO 2.
2.CHECK SYMPTOM
• Check the symptom based on the information obtained from the customer.
• Check if any other malfunctions are present.
>> GO TO 3.
3.CONSULT-III SELF-DIAGNOSIS
Perform “MULTI DISPLAY” “self diagnosis” by connecting CONSULT-III.
NOTE
:
If “CAN COM CIRC [U1000]” is displayed, start the diagnosis from the CAN
communication system. AV-116,
"Diagnosis Procedure".
Is any DTC No. displayed? YES >> GO TO 4.
NO >> GO TO 5.
4.DTC/SYSTEM DIAGNOSIS
Perform a DTC/system diagnosis and repair or replace any malfunctioning part.
>> GO TO 6.
5.PERFORM DIAGNOSIS BY SYMPTOM
Perform a diagnosis by symptom and repair or replace any malfunctioning part.
>> GO TO 6.
6.FINAL CHECK
Check that the multi display unit functions normally.
Does it operate normally? YES >> End of trouble diagnosis NO >> GO TO 2.
Wiring diagram
NISSAN DYNAMIC CONTROL SYSTEM Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, &qu ...Removal and installation
MULTI DISPLAY UNIT Exploded View REMOVAL Refer to IP-12, "Exploded View". DISASSEMBLY 1. Silencer tape 2. Multi display unit 3. Silencer tape 4. Clip 5. Control finisher Rem ...Other materials:
Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
DESCRIPTION OF TROUBLE DIAGNOSIS FLOWCHART
DETAILS OF TROUBLE DIAGNOSIS FLOWCHART
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the
conditions and environment under
which the malfunction oc ...
Mainshaft and gear
Exploded View
1. Mainshaft front bearing outer
race
2. Mainshaft front bearing inner race
3. Mainshaft
4. 1st main gear
5. 1st inner baulk ring
6. 1st synchronizer cone
7. 1st outer baulk ring
8. Spread spring
9. 1st-2nd synchronizer hub
10. 1st-2nd coupling sleeve
11. 2nd outer ...
P0507 ISC system
Description
The ECM controls the engine idle speed to a specified level through the fine
adjustment of the air, which is let
into the intake manifold, by operating the electric throttle control actuator.
The operating of the throttle valve is
varied to allow for optimum control of the engine ...