Nissan Juke Service and Repair Manual : Basic inspection
- Diagnosis and repair workflow
- Charging system preliminary inspection
- Power generation voltage variable control system operation inspection
Wiring diagram
CHARGING SYSTEM Wiring Diagram GASOLINE ENGINE MODELS For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to ...Diagnosis and repair workflow
Gasoline engine models GASOLINE ENGINE MODELS : Work Flow OVERALL SEQUENCE DETAILED FLOW 1.PRELIMINARY INSPECTION Perform the preliminary inspection. Refer to CHG-17, "Inspection Procedure ...Other materials:
B1058, B1059, B1060, B1061, B1062, B1063 diagnosis sensor unit
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW FOR MALFUNCTION
Interview the symptom to the customer.
>> GO TO 2.
2.SYMPTOM CHECK
Check the symptom from the customer's information.
>> GO TO 3.
3.BASIC INSPECTION
Check the operation o ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...