Nissan Juke Service and Repair Manual : Basic inspection
RHD
RHD : Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information ...Additional service when replacing control unit
Description BEFORE REPLACEMENT When replacing BCM, save or print current vehicle specification with CONSULT-III configuration before replacement. NOTE: If “READ CONFIGURATION” can not be used ...Other materials:
Vehicle jerks during
Description
The vehicle jerks when ABS function and EBD function operates.
Diagnosis Procedure
1.CHECK SYMPTOM
Check that the vehicle jerks when ABS function and EBD function operates.
Is the inspection result normal?
YES >> Normal
NO >> GO TO 2.
2.PERFORM SELF-DIAGNOSIS
Wit ...
B2198 nats antenna AMP.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE 1
1. Contact Intelligent Key backside to push-button ignition switch.
2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected?
YES >> Go to SEC-65, "D ...
Rear wiper auto stop signal circuit
Component Function Check
1.CHECK REAR WIPER (AUTO STOP) OPERATION
CONSULT-III DATA MONITOR
1. Select “WIPER” of BCM data monitor item.
2. Operate the rear wiper.
3. Check that “RR WIPER STOP” changes to “On” and “Off” linked with the wiper
operation.
Is the status of item normal?
YES > ...