Nissan Juke Service and Repair Manual : Basic inspection
- Diagnosis and repair work flow
- Additional service when replacing TCM
- Additional service when replacing transaxle assembly
- G sensor calibration
- CVT fluid
- Stall test
- Line pressure test
- CVT position
CVT shift lock system
Wiring diagram connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanatio ...Diagnosis and repair work flow
Flowchart of Trouble Diagnosis NOTE: “DTC” includes DTC at the 1st trip. 1.OBTAIN INFORMATION ABOUT SYMPTOM 1. Refer to TM-372, "Question sheet" and interview the customer to obtain th ...Other materials:
C1109 power and ground system
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...
NISSAN Vehicle Immobilizer System
The NISSAN Vehicle Immobilizer System will not allow the engine to start without
the use of the registered key.
If the engine fails to start using the registered key, it may be due to interference
caused by another registered key, an automated toll road device or automated payment
device on t ...
C1609 vehicle speed signal
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With ...