Nissan Juke Service and Repair Manual : Basic inspection
- Diagnosis and repair workflow
- Additional service when replacing TCM
- Additional service when replacing transaxle assembly
- Calibration of decel G sensor
- Idle neutral control learning
- CVT fluid
- Stall test
- Line pressure test
- Road test
- CVT position
CVT shift lock system
Wiring diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if notdescribed in wiring diagram), refer to GI-12, "Connector Information/Expla ...Diagnosis and repair workflow
Work Flow INTRODUCTION The TCM receives a signal from the vehicle speed sensor, transmission range switch and provides shift control or lock-up control via CVT solenoid valves. The TCM also co ...Other materials:
Precaution for Brake System
WARNING:
Clean any dust from the front brake and rear brake with a vacuum dust collector.
Never blow with compressed
air.
• Brake fluid use refer to MA-13, "Fluids and Lubricants".
• Never reuse drained brake fluid.
• Never spill or splash brake fluid on painted surfaces. Brake flui ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
Fan control amplifier
Exploded View
1. A/C unit assembly
2. Fan control amp.*1
3. Blower fan resistor*2
4. Blower motor
5. Blower motor cover
• *1: Automatic air conditioner
• *2: Manual air conditioner
Removal and Installation
REMOVAL
1. Remove instrument panel assembly. Refer to IP-13, "Removal and ...