Nissan Juke Service and Repair Manual : Back door opener system

System Diagram

System Description


System Description

BACK DOOR OPENER OPERATION

When back door opener switch is pressed, BCM operates back door opener actuator.

NOTE

:
Back door opener actuator is not for locking the back door. The function is only to open the back door.

OPERATION CONDITION

If the following conditions are satisfied, back door opener operation is performed.

NOTE:


NOTE

:
• When battery terminal is disconnected and reconnected during all doors unlock state, back door may not open.

• Regardless of door lock actuator state, BCM resets recognition of all doors unlock state approximately 30 seconds after battery terminal is disconnected and BCM recognizes that all doors are in lock state.

• When battery terminal is reconnected and back door does not open, have BCM recognize that all doors are in unlock state.

    Remote keyless entry system
    Remote keyless entry function REMOTE KEYLESS ENTRY FUNCTION : System Diagram REMOTE KEYLESS ENTRY FUNCTION : System Description DOOR LOCK AND UNLOCK OPERATION • When door lock and unlock button ...

    Diagnosis system (BCM)
    Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perfo ...

    Other materials:

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

    System setting
    Temperature Setting Trimmer DESCRIPTION If the temperature felt by the customer is different from the air flow temperature controlled by the temperature setting, the A/C auto amp. control temperature can be adjusted to compensate for the temperature setting. HOW TO SET With CONSULT-III P ...

    Hood
    Exploded View 1. Hood assembly 2. Hood bumper rubber 3. Radiator core seal 4. Hood bumper rubber 5. Clamp 6. Hood hinge 7. Grommet 8. Hood support rod : Clip : Pawl : Body grease Hood assembly HOOD ASSEMBLY : Removal and Installation CAUTION: • Operate with two workers, because ...