Nissan Juke Service and Repair Manual : Back door opener switch

Component Function Check

1.CHECK FUNCTION

1. Select “TRUNK” of “BCM” using CONSULT-III.

2. Select “TRNK OPNR SW” in “DATA MONITOR” mode.

3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?


Is the inspection result normal? YES >> Back door opener switch is OK.

NO >> Refer to DLK-384, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK BACK DOOR OPEN INPUT SIGNAL

1. Turn ignition switch OFF.

2. Disconnect back door opener switch connector.

3. Check signal between back door opener switch harness connector and ground using oscilloscope.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 3.

NO >> GO TO 2.

2.CHECK BACK DOOR OPENER SWITCH CIRCUIT

1. Disconnect BCM connector.

2. Check continuity between BCM harness connector and back door opener switch harness connector.

3. Check continuity between BCM harness connector and ground.


3. Check continuity between BCM harness connector and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> Replace BCM. Refer to BCS-161, "Removal and Installation".

NO >> Repair or replace harness.

3.CHECK BACK DOOR OPENER SWITCH GROUND CIRCUIT

Check continuity between back door opener switch harness connector and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace harness.

4.CHECK BACK DOOR OPENER SWITCH

Refer to DLK-385, "Component Inspection".

Is the inspection result normal? YES >> GO TO 5.

NO >> Replace back door opener switch.

5.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> INSPECTION END

Component Inspection

1.CHECK BACK DOOR OPENER SWITCH

1. Turn ignition switch OFF.

2. Disconnect back door opener switch connector.

3. Check continuity between back door opener switch terminals.

Is the inspection result normal?


Is the inspection result normal? YES >> INSPECTION END

NO >> Replace back door opener switch.

    Back door opener actuator
    Diagnosis Procedure 1.CHECK BACK DOOR OPENER ACTUATOR INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect back door opener assembly connector. 3. Check voltage between back door opener assembl ...

    Door lock actuator
    Driver side DRIVER SIDE : Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK” in “ACTIVE TEST” mode. 3. Check that the function opera ...

    Other materials:

    Rear disc brake
    Brake pad : Exploded View 1. Sliding pin bolt 2. Cylinder body 3. Inner shim cover 4. Inner shim 5. Inner pad (with pad wear sensor) 6. Pad retainer 7. Torque member 8. Outer pad 9. Outer shim 10. Outer shim cover 1 Apply rubber grease. 2: Apply MOLYKOTE® AS880N or silicone-bas ...

    P0643 sensor power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following proced ...

    4WD warning lamp blinks quickly
    Description While driving, 4WD warning lamp blinks 2 times in 1 second and it turns OFF after 1 minute. NOTE: • This symptom protects drivetrain parts when a heavy load is applied to the electric controlled coupling and multiple disc clutch temperature increases. Also, optional distributio ...