Nissan Juke Service and Repair Manual : Back door opener actuator

Diagnosis Procedure

1.CHECK BACK DOOR OPENER ACTUATOR INPUT SIGNAL

1. Turn ignition switch OFF.

2. Disconnect back door opener assembly connector.

3. Check voltage between back door opener assembly harness connector and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 3.

NO >> GO TO 2.

2.CHECK BACK DOOR OPENER ACTUATOR CIRCUIT

1. Disconnect BCM connector.

2. Check continuity between BCM harness connector and back door opener assembly harness connector.

3. Check continuity between BCM harness connector and ground.


3. Check continuity between BCM harness connector and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> Replace BCM. Refer to BCS-161, "Removal and Installation".

NO >> Repair or replace harness.

3.CHECK BACK DOOR OPENER ACTUATOR GROUND CIRCUIT

Check continuity between back door opener assembly harness connector and ground.

Is the inspection normal?


Is the inspection normal? YES >> Replace back door opener assembly.

NO >> Repair or replace harness.

    Back door opener switch
    Component Function Check 1.CHECK FUNCTION 1. Select “TRUNK” of “BCM” using CONSULT-III. 2. Select “TRNK OPNR SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to t ...

    Other materials:

    Harness layout
    LHD LHD : How To Read Harness Layout CONNECTOR SYMBOL Main symbols of connector (in Harness Layout) are indicated in the below. LHD : Engine Room Harness ENGINE COMPARTMENT PASSENGER COMPARTMENT LHD : Engine Control Harness HR ENGINE MR ENGINE K9K ENGINE LHD : Main Harness ...

    P0014 EVT control
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0014 is displayed with DTC P0078, first perform trouble diagnosis for DTC P0078. Refer to EC- 585, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver a ...