Nissan Juke Service and Repair Manual : Back door lock

Exploded View

1. Back door lock assembly 2. TORX bolt 3. Back door striker


1. Back door lock assembly 2. TORX bolt 3. Back door striker

: N·m (kg-m, ft-lb): Do not reuse
: Body grease: N·m (kg-m, ft-lb)
Door lock: Body grease


Door lock

DOOR LOCK : Removal and Installation

REMOVAL

1. Remove the back door lower finisher. Refer to INT-35, "BACK DOOR LOWER FINISHER : Removal and Installation".

2. Remove back door lock assembly mounting bolts.

3. Disconnect back door lock connector, and then remove back door lock assembly.

INSTALLATION

Note the following item, and install in the reverse order of removal.

CAUTION:
After installation, check back door open/close, and lock/unlock operation.

Emergency lever

EMERGENCY LEVER : Unlock procedures

UNLOCK PROCEDURES

NOTE

:
If back door lock cannot be unlocked due to a malfunction or battery discharge, follow the procedures to unlock back door.

1. Remove emergency lid. Refer to INT-36, "EMERGENCY LID : Removal and Installation".

2. From inside the vehicle, rotate emergency lever toward lower direction and unlock.

Fuel filler lid opener


    Rear door lock
    Exploded View 1. Outside handle assembly 2. Inside handle 3. TORX bolt 4. Door lock assembly 5. Rear door sealing screen : Clip : Pawl : Vehicle front : Do not reuse : N·m (kg-m, in-lb) ...

    Fuel filler lid opener
    Exploded View 1. Fuel filler lid opener cable 2. Cable protector 3. Fuel filler lid lock assembly 4. Fuel filler lid assembly 5. Spring 6. Bumper rubber : Clip : Do not reuse Fuel fille ...

    Other materials:

    Power supply and ground circuit
    Diagnosis Procedure 1.CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible links are not blown. Is the fuse fusing? YES >> Replace the blown fuse or fusible link after repairing the affected circuit if a fuse or fusible link is blown. NO >> GO TO 2. ...

    Precaution
    Precautions for Drive Shaft • Observe the following precautions when disassembling and assembling drive shaft. - Never disassemble joint sub-assembly because it is non-overhaul parts. - Perform work in a location which is as dust-free as possible. - Clean the parts, before disassembling and ...

    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
    The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is include ...