Nissan Juke Service and Repair Manual : Back door lock

Exploded View

1. Back door lock assembly


1. Back door lock assembly 2. TORX bolt
3. Back door striker

: N·m (kg-m, ft-lb): Do not reuse
: Body grease: N·m (kg-m, ft-lb)
Door lock: Body grease


Door lock

DOOR LOCK : Removal and Installation

REMOVAL

1. Remove the back door lower finisher. Refer to INT-35, "BACK DOOR LOWER FINISHER : Removal and Installation".

2. Remove back door lock assembly mounting bolts.

3. Disconnect back door lock connector, and then remove back door lock assembly.

INSTALLATION

Note the following item, and install in the reverse order of removal.

CAUTION:
After installation, check back door open/close, and lock/unlock operation.

Emergency lever

EMERGENCY LEVER : Unlock procedures

UNLOCK PROCEDURES

NOTE

:
If back door lock cannot be unlocked due to a malfunction or battery discharge, follow the procedures to unlock back door.

1. Remove emergency lid. Refer to INT-36, "EMERGENCY LID : Removal and Installation".

2. From inside the vehicle, rotate emergency lever toward lower direction and unlock.

Fuel filler lid opener


    Rear door lock
    Exploded View 1. Outside handle assembly 2. Inside handle 3. TORX bolt 4. Door lock assembly 5. Rear door sealing screen : Clip : Pawl : Vehicle front : Do not reuse : N·m (kg-m, in-lb) ...

    Fuel filler lid opener
    Exploded View 1. Fuel filler lid opener cable 2. Cable protector 3. Fuel filler lid lock assembly 4. Fuel filler lid assembly 5. Spring 6. Bumper rubber : Clip : Do not reuse Fuel fille ...

    Other materials:

    B1087 seat belt Pre-tensioner LH
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

    Door lock and unlock switch
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “CDL LOCK SW”, “CDL UNLOCK SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Doo ...

    Light & rain sensor
    Exploded View CAUTION: When the light & rain sensor is removed from windshield, the light & rain sensor cannot be re-used. REMOVAL 1. Light & rain sensor bracket 2. Mirror base 3. Light & rain sensor 4. Inside mirror assembly : Pawl : Do not reuse Removal and Installa ...