Nissan Juke Service and Repair Manual : B terminal circuit

Description

“B” terminal circuit supplies power to charge the battery and to operate the vehicle’s electrical system.

Diagnosis Procedure

1.CHECK “B” TERMINAL CONNECTION

1. Turn ignition switch OFF.

2. Check if “B” terminal is clean and tight.

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair “B” terminal connection.

2.CHECK “B” TERMINAL CIRCUIT

Check voltage between alternator “B” terminal and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 3.

NO >> Check harness for open between alternator and fusible link.

3.CHECK “B” TERMINAL CONNECTION (VOLTAGE DROP TEST)

1. Start engine, then engine running at idle and warm.

2. Check voltage between battery positive terminal and alternator “B” terminal.

Is the inspection result normal?


Is the inspection result normal? YES >> “B” terminal circuit is normal. Refer to CHG-12, "GASOLINE ENGINE MODELS : Work Flow" (gasoline engine models) or CHG-15, "DIESEL ENGINE MODELS : Work Flow" (diesel engine models).

NO >> Check harness between battery and alternator for poor continuity.

    L terminal circuit (open)
    Description The “L” terminal circuit controls the charge warning lamp. The charge warning lamp illuminates when the ignition switch is set to ON or START. When the alternator is providing sufficie ...

    Other materials:

    ACC warning does not operate
    Diagnosis Procedure 1.CHECK COMBINATION METER BUZZER Check combination meter buzzer. Refer to WCS-40, "Component Function Check". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning parts. 2.REPLACE BCM 1. Replace BCM. Ref ...

    Wiring diagram
    NISSAN DYNAMIC CONTROL SYSTEM Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...