Nissan Juke Service and Repair Manual : B26FC key registration

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Perform initialization of BCM and reregistration of all Intelligent Keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-133, "Diagnosis Procedure" NO >> INSPECTION END

Diagnosis Procedure

1.REPLACE INTELLIGENT KEY

1. Prepare Intelligent Key that matches the vehicle.

2. Perform initialization of BCM and registration of Intelligent Key using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

3. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

>> INSPECTION END

    B26FB clutch switch
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26FB is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26FB is disp ...

    B209F cranking request circuit
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC B209F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS- 30, "DTC Logic". DTC CONFIRMATION PROC ...

    Other materials:

    P0746 pressure control solenoid A
    Description The line pressure solenoid valve regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMAT ...

    DLC branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side). Is the inspection res ...

    Radiator
    Exploded View 1. Cooling fan assembly 2. Mounting rubber (upper) 3. Radiator 4. Mounting rubber (lower) 5. O-ring 6. Drain plug 7. Clamp 8. Radiator hose (lower) (LH) 9. Reservoir tank hose 10. Reservoir tank 11. Reservoir tank cap 12. Clamp 13. Radiator hose (upper) 14. Water ...