Nissan Juke Service and Repair Manual : B26F7 BCM

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Press door request switch.

2. Turn ignition switch ON.

3. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-127, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Select “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC CONFIRMATION PROCEDURE for DTC B26F7. Refer to SEC-126, "DTC Logic".

Is DTC detected? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

>> INSPECTION END

    B26F5 steering lock status switch
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26F5 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26F5 is disp ...

    B26F8 BCM
    DTC Logic DTC DETECTION LOGIC NOTE: DTC B26F8 can be detected even though the related circuit is not used in this vehicle. DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. ...

    Other materials:

    Removal and Installation
    REMOVAL 1. Remove rear propeller shaft assembly. Refer to DLN-121, "Removal and Installation". 2. Remove rear drive shaft. Refer to RAX-17, "Removal and Installation". 3. Disconnect sub-harness connector (1). 4. Remove rear final drive breather hose. 5. Support rear final ...

    B261F ASCD clutch switch
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B261F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B261F is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "D ...

    Power supply and ground circuit
    Diagnosis Procedure 1.CHECK 4WD CONTROL MODULE POWER SUPPLY (1) 1. Turn the ignition switch OFF. 2. Disconnect 4WD control module harness connector. 3. Check the voltage between 4WD control module harness connector and ground. 4. Turn the ignition switch ON. CAUTION: Never start the engin ...