Nissan Juke Service and Repair Manual : B26F1 ignition relay

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions, and wait for 2 seconds or more.

CVT models
- Selector lever is in the P or N position - Do not depress brake pedal

M/T models
- Do not depress clutch pedal

2. Check “Self-diagnosis result” with CONSULT-III.

Is DTC detected? YES >> Go to PCS-103, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK IPDM E/R SELF-DIAGNOSTIC RESULT

1. Turn ignition switch ON.

2. Erase the DTC of IPDM E/R.

3. Turn ignition switch OFF.

4. Turn ignition switch ON and check the DTC again.

Is DTC detected? YES >> Repair or replace the malfunctioning part. Refer to PCS-25, "DTC Index".

NO >> GO TO 2.

2.CHECK IGNITION RELAY (IPDM E/R) CONTROL SIGNAL

Check voltage between BCM harness connector and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 3.

NO >> Replace BCM. Refer to BCS-93, "Removal and Installation".

3.CHECK IGNITION RELAY (IPDM E/R) CONTROL SIGNAL CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BCM and IPDM connectors.

3. Check continuity between BCM harness connector and IPDM E/R harness connector.

Is the inspection result normal?


Is the inspection result normal? YES >> Replace IPDM E/R.

NO >> Repair or replace harness.

    B261A push-button ignition switch
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B261A is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B261A is disp ...

    B26F2 ignition relay
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON under the following conditions, and wait for 2 seconds or more. CVT ...

    Other materials:

    System (power door lock system)
    System Diagram System Description DOOR LOCK FUNCTION Door Lock and Unlock Switch • The door lock and unlock switch (driver side) is build into power window main switch. • The door lock and unlock switch (passenger side) is build into front power window switch (passenger side). • Interloc ...

    Keyfob id registration
    Description Perform the following procedure after BCM is replaced or when new keyfob ID is registered NOTE: When registering the keyfob ID, perform only one procedure to simultaneously register both ID (IMMOBILIZER ID and keyfob ID). Work Procedure 1.STEP 1 Close all doors. >> GO ...

    Auto door lock operation does not operate
    Diagnosis Procedure 1.CHECK “AUTO LOCK SET” SETTING WITH CONSULT-III 1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III. 2. Select “AUTO LOCK SET” in “WORK SUPPORT” mode. 3. Check “AUTO LOCK SET” in “WORK SUPPORT”. Refer to DLK-502, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MU ...