Nissan Juke Service and Repair Manual : B26E9 steering status

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Turn ignition switch OFF.

3. Press driver side door switch.

4. Turn ignition switch ON.

5. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Refer to SEC-116, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Select “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC CONFIRMATION PROCEDURE for DTC B26E9. Refer to SEC-116, "DTC Logic".

Is DTC detected? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE STEERING LOCK UNIT

1. Replace steering lock unit.

2. Perform the service procedure for steering lock unit replacement. Refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

>> INSPECTION END

    B26E8 clutch interlock switch
    DTC Logic NOTE: • If DTC B26E8 is displayed with DTC B210F, first perform the trouble diagnosis for DTC B210F. Refer to BCS-83, "DTC Logic". • If DTC B26E8 is displayed with DTC B2110, ...

    B26EF steering lock relay
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26EF is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26EF is disp ...

    Other materials:

    System
    POWER WINDOW SYSTEM POWER WINDOW SYSTEM : System Diagram POWER WINDOW SYSTEM : System Description • Power window system is activated by power window switch when ignition switch turns ON. • Power window main switch opens/closes all door glass. • Front and rear power window switch opens/close ...

    P0962 pressure control solenoid A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...

    Handling for Adhesive and Primer
    • Never use an adhesive that is past its usable date. Shelf life of this product is limited to six months after the date of manufacture. Carefully adhere to the expiration or manufacture date printed on the box. • Keep primers and adhesive in a cool, dry place. Ideally, they should be stored ...