Nissan Juke Service and Repair Manual : B2623 inside antenna

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.

2. Select “INSIDE ANT DIAGNOSIS” in “WORK SUPPORT” mode.

3. Perform inside key antenna (“INSIDE ANT DIAGNOSIS”) on “WORK SUPPORT” of “INTELLIGENT KEY”.

4. Check BCM for DTC.

Is inside key antenna DTC detected? YES >> Refer to DLK-234, "Diagnosis Procedure".

NO >> Inside key antenna (luggage room) is OK.

Diagnosis Procedure

1.CHECK INSIDE KEY ANTENNA INPUT SIGNAL 1

1. Turn ignition switch ON.

2. Check signal between BCM harness connector and ground using oscilloscope.

Is the inspection result normal?


Is the inspection result normal? YES >> Replace BCM. Refer to BCS-93, "Removal and Installation".

NO >> GO TO 2.

2.CHECK INSIDE KEY ANTENNA CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BCM connector and inside key antenna (luggage room) connector.

3. Check continuity between BCM harness connector and inside key antenna


3. Check continuity between BCM harness connector and inside key antenna (luggage room) harness connector.

4. Check continuity between BCM harness connector and ground.


4. Check continuity between BCM harness connector and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace harness.

3.CHECK INSIDE KEY ANTENNA INPUT SIGNAL 2

1. Replace inside key antenna (luggage room). (New antenna or other antenna)
2. Connect BCM connector and inside key antenna (luggage room) connector.

3. Turn ignition switch ON.

4. Check signal between BCM harness connector and ground using oscilloscope.

Is the inspection result normal?


Is the inspection result normal? YES >> Replace inside key antenna (luggage room).

NO >> Replace BCM. Refer to BCS-93, "Removal and Installation".

    B2622 inside antenna
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “INSIDE ANT DIAGNOSIS” in “WORK S ...

    B2626 OUTSIDE ANTENNA
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Disconnect outside key antenna (driver side) connector. 2. Perform “INTELLIGENT KEY” Self Diagno ...

    Other materials:

    Fuel recommendation
    NISSAN recommends the use of unleaded premium gasoline with an octane rating of at least 91 AKI (Anti-Knock Index) number (Research octane number 96). If unleaded premium gasoline is not available, you may use unleaded regular gasoline with an octane rating of at least 87 AKI number (Research o ...

    Front door
    Exploded View 1. Front door panel 2. Grommet 3. Door hinge (upper) 4. Door hinge (lower) 5. Door check link 6. Bumper rubber 7. Door pad 8. Door striker 9. TORX bolt 10. Grommet : Do not reuse : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) : Body grease Door assembly DOOR ASSEMBLY : ...

    Diagnosis and repair workflow
    Work Flow OVERALL SEQUENCE • Malfunctions are declared as either present or stored (depending on whether they appeared in a certain context and have disappeared since, or whether they remain present but have not been diagnosed within the current context). • The present or stored status of ...