Nissan Juke Service and Repair Manual : B2562 low voltage
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.DTC CONFIRMATION
1. Erase DTC.
2. Turn ignition switch OFF.
3. Perform the “Self Diagnostic Result” of BCM with CONSULT-III, when passed 120 seconds or more after the ignition switch is turned ON.
Is any DTC detected? YES >> Refer to BCS-86, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK POWER SUPPLY CIRCUIT
Check BCM power supply circuit. Refer to BCS-87, "Diagnosis Procedure".
Is the circuit normal? YES >> Replace BCM. Refer to BCS-93, "Removal and Installation".
NO >> Repair the malfunctioning part.
U0415 vehicle speed
Description
U0415 is displayed if any unusual condition is present in the reception
status of the vehicle speed signal from
the ABS actuator and electric unit (control unit).
DTC Logic
DTC DETEC ...
Power supply and ground circuit
Diagnosis Procedure
1.CHECK FUSE AND FUSIBLE LINK
Check that the following fuse and fusible link are not blown.
Is the fuse fusing?
YES >> Replace the blown fuse or fusible link after repa ...
Other materials:
Diagnosis system (IPDM E/R)
Consult-III Function (IPDM E/R)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with IPDM
E/R.
SELF DIAGNOSTIC RESULT
Refer to PCS-25, "DTC Index".
DATA MONITOR
Monitor item
ACTIVE TEST
Test item
...
SRS air bag warning lamp does not turn on
Diagnosis Procedure
1.CHECK COMBINATION METER POWER SUPPLY AND GROUND CIRCUIT
Check conbination meter unit power supply and ground circuit. Refer to
MWI-51, "COMBINATION METER :
Diagnosis Procedure".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or r ...
Brake pad wear warning
The disc brake pads have audible wear warnings.
When a brake pad requires replacement, it will make a high pitched scraping sound
when the vehicle is in motion. This scraping sound will first occur only when the
brake pedal is depressed. After more wear of the brake pad, the sound will always
...
