Nissan Juke Service and Repair Manual : B2195 anti-scanning

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Refer to SEC-206, "Diagnosis Procedure".

NO >> INSPECTION END.

Diagnosis Procedure

1.CHECK SELF DIAGNOSTIC RESULT 1

1. Select “Self Diagnostic Result” of “BCM” using CONSULT-III.

2. Erase DTC.

3. Perform DTC Confirmation Procedure for DTC P2195. Refer to SEC-206, "DTC Logic".

Is DTC detected? YES >> GO TO 2.

NO >> INSPECTION END

2.CHECK EQUIPMENT OF THE VEHICLE

Check that unspecified accessory part related to engine start is not installed.

Is unspecified accessory part related to engine start installed? YES >> GO TO 3.

NO >> Replace BCM. Refer to BCS-161, "Removal and Installation".

3.CHECK SELF DIAGNOSTIC RESULT 2

1. Obtain the customers approval to remove unspecified accessory part related to engine start, and then remove it.

2. Select “Self Diagnostic Result” of “BCM” using CONSULT-III.

3. Erase DTC.

4. Perform DTC CONFIRMATION PROCEDURE for for DTC B2195. Refer to SEC-206, "DTC Logic".

Is DTC detected? YES >> GO TO 4.

NO >> INSPECTION END

4.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Perform initialization of BCM and reregistration of all ignition keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

>> INSPECTION END

    B2193 chain of ECM-IMMU
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2193 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-153, "DTC Logic". • If DTC B2193 is dis ...

    B2196 dongle unit
    Description BCM performs ID verification between BCM and dongle unit. When verification result is OK, BCM permits cranking. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM ...

    Other materials:

    Rear oil seal
    REAR OIL SEAL : Removal and Installation REMOVAL 1. Remove transaxle assembly. Refer to TM-301, "Exploded View" (CVT models) or TM-84, "MR16DDT : Exploded View" (M/T models). 2. Remove clutch cover and clutch disk (M/T models). Refer to CL-29, "EXCEPT FOR K9K : Explo ...

    Auto door lock operation does not operate
    Diagnosis Procedure 1.CHECK “AUTO LOCK SET” SETTING IN “WORK SUPPORT” 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “AUTO LOCK SET” in “WORK SUPPORT” mode. 3. Check “AUTO LOCK SET” in “WORK SUPPORT”. Refer to DLK-219, "INTELLIGENT KEY : CONSULT-III Function (BCM - INT ...

    Diagnosis system (A/C auto AMP.)
    Description Air conditioning system performs self-diagnosis, operation check, function diagnosis, and various settings using diagnosis function of each control unit. CONSULT-III Function CONSULT-III performs the following functions via CAN communication with A/C auto amp. NOTE: Diagnos ...