Nissan Juke Service and Repair Manual : B2195 anti-scanning

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Refer to SEC-62, "Diagnosis Procedure".

NO >> INSPECTION END.

Diagnosis Procedure

1.CHECK SELF DIAGNOSTIC RESULT 1

1. Select “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

2. Erase DTC.

3. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to SEC-62, "DTC Logic".

Is DTC detected? YES >> GO TO 2.

NO >> INSPECTION END

2.CHECK EQUIPMENT OF THE VEHICLE

Check that unspecified accessory part related to engine start is not installed.

Is unspecified accessory part related to engine start installed? YES >> GO TO 3.

NO >> GO TO 4.

3.CHECK SELF DIAGNOSTIC RESULT 2

1. Obtain the customers approval to remove unspecified accessory part related to engine start, and then remove it.

2. Select “Self Diagnostic Result” of “BCM” using CONSULT-III.

3. Erase DTC.

4. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to SEC-62, "DTC Logic".

Is DTC detected? YES >> GO TO 4.

NO >> INSPECTION END

4.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

>> INSPECTION END

    B2193 chain of ECM-IMMU
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2193 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B2193 is disp ...

    B2196 dongle unit
    Description BCM performs ID verification between BCM and dongle unit. When verification result is OK, BCM permits cranking. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM ...

    Other materials:

    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
    The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is include ...

    Front coil spring and strut
    Exploded View 2WD 1. Piston rod lock nut 2. Mounting insulator 3. Mounting bearing 4. Bound bumper 5. Coil spring 6. Lower rubber seat 7. Strut 8. Steering knuckle : N·m (kg-m, ft-lb) : Always replace after every disassembly 4WD 1. Piston rod lock nut 2. Mounting insulator ...

    Unexpected brake pedal reaction
    Description A malfunction of brake pedal feel (height or others) is detected when brake pedal is depressed. Diagnosis Procedure 1.CHECK FRONT AND REAR AXLE Check that there is no excessive looseness in front and rear axle. • Front axle - MR16DDT: Refer to FAX-9, "Inspection". - ...