Nissan Juke Service and Repair Manual : B209F cranking request circuit

DTC Logic

DTC DETECTION LOGIC

NOTE

:
If DTC B209F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS- 30, "DTC Logic".

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Perform DTC CONFIRMATION PROCEDURE for DTC P1650. Refer to EC-366, "DTC Logic" (MR16DDT) or EC-725, "DTC Logic" (HR16DE).

2. Turn ignition switch ON.

3. Check DTC in “Self Diagnostic Result” mode of “IPDM E/R” using CONSULT-III.

Is DTC detected? YES >> Refer to SEC-134, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK CRANKING REQUEST SIGNAL

1. Turn ignition switch ON.

2. Check voltage between IPDM E/R harness connector and ground under the following conditions.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 3.

NO >> GO TO 2.

2.CHECK CRANKING REQUEST SIGNAL CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect IPDM E/R connector.

3. Disconnect ECM connector.

4. Check continuity between IPDM E/R harness connector and ECM harness connector.

5. Check continuity between BCM harness connector and ground.


5. Check continuity between BCM harness connector and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace harness.

3.REPLACE IPDM E/R

1. Replace IPDM E/R. Refer to PCS-34, "Removal and Installation".

2. Perform DTC CONFIRMATION PROCEDURE for DTC B209F. Refer to SEC-134, "DTC Logic".

Is DTC detected? YES >> GO TO 4.

NO >> INSPECTION END

4.REPLACE ECM

Replace ECM.

Refer to EC-447, "Removal and Installation" (MR16DDT) or EC-805, "Removal and Installation" (HR16DE).

>> INSPECTION END

    B26FC key registration
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Perform initialization of BCM and reregistration of all Intelligent Keys using CONSULT-III. ...

    B20A0 cranking request circuit
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC B20A0 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS- 30, "DTC Logic". DTC CONFIRMATION PROC ...

    Other materials:

    P0863 TCM communication
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION With ...

    How to Follow Test Groups in Trouble Diagnosis
    1. Test group number and test group title • Test group number and test group title are shown in the upper portion of each test group. 2. Work and diagnosis procedure • Start to diagnose a problem using procedures indicated in enclosed test groups. 3. Questions and results • Questions ...

    Control buttons
    The control buttons for the Bluetooth® Hands- Free Phone System are located on the steering wheel. PHONE SEND Push the button to initiate a VR session or answer an incoming call. You can also use the button to interrupt system feedback and give a command at once. PHONE END While the ...