Nissan Juke Service and Repair Manual : B2098 ignition relay on stuck
Description
The ignition relay integrated in IPDM E/R is operated with ignition switch ON signal from the ignition switch.
DTC Logic
DTC DETECTION LOGIC
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Check DTC in “Self Diagnostic Result” mode of “IPDM E/R” using CONSULT-III.
Is DTC detected? YES >> Refer to PCS-60, "Diagnosis Procedure".
NO >> INSPECTION END.
Diagnosis Procedure
1.CHECK IGNITION SWITCH ON SIGNAL
Check voltage between BCM harness connectors and the ground.
Is the measurement value normal? YES >> Replace BCM. Refer to BCS-161, "Removal and Installation".
NO >> GO TO 2.
2.CHECK IGNITION SWITCH ON SIGNAL CIRCUIT
1. Turn the ignition switch OFF.
2. Disconnect IPDM E/R harness connectors.
3. Check continuity between IPDM E/R harness connectors and BCM harness connectors.
Does continuity exist? YES >> Replace IPDM E/R. Refer to PCS-63, "Removal and Installation".
NO >> Repair the harness or connector.
U1000 can comm circuit
Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excelle ...B2099 ignition relay off stuck
Description The ignition relay integrated in IPDM E/R is operated with ignition switch ON signal from the ignition switch. DTC Logic DTC DETECTION LOGIC NOTE: When IPDM E/R power supply volta ...Other materials:
Diagnosis system (BCM)
Common item
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the ...
Exterior and interior lights
: See a NISSAN dealer for replacement.
NOTE: Always check with the Parts Department at a NISSAN dealer for the latest
information about parts.
: REMOVE
: INSTALL
Replacement procedures
All other lights are either type A, B, C, D or E.
When replacing a bulb, first remove the lens and/or c ...
Keyfob battery
Component Function Check
1.CHECK FUNCTION
Check door lock and unlock operation with keyfob button.
Is the inspection result normal?
YES >> Keyfob is OK.
NO >> Refer to DLK-403, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK KEYFOB BATTERY
Check by connecting a r ...