Nissan Juke Service and Repair Manual : B1210 side collision detection
Description
The side air bag and curtain air bag are activated by the air bag diagnosis sensor unit signal transmitted at the time of side collision.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to SRC-12, "On Board Diagnosis Function".
NOTE
:
SRS does not enter the diagnosis mode if no malfunction is detected in the user
mode.
Is malfunctioning part detected? YES >> Refer to SRC-141, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
WARNING:
• Before servicing, turn ignition switch OFF, disconnect battery negative
terminal, and wait at least 3
minutes or more. (To discharge backup capacitor.)
• Never use unspecified tester or other measuring device.
1.PERFORM COLLISION DIAGNOSIS
Perform collision diagnosis.Refer to SR-8, "FOR SIDE AND ROLLOVER COLLISION : When SRS is activated in a collision" or SR-9, "FOR SIDE AND ROLLOVER COLLISION : When SRS is not activated in a collision".
Is collision diagnosis complete? YES >> GO TO 2.
NO >> INSPECTION END
2.FINAL INSPECTION
Perform “AIR BAG” Self Diagnostic Result.
Is the inspection result normal? YES >> INSPECTION END
NO >> Perform diagnosis of applicable DTC.Refer to SRC-18, "DTC Index".
B1209 frontal collision detection
Description The air bags and seat belt pre-tensioners for driver and passenger are activated by the air bag diagnosis sensor unit signal transmitted at the time of the frontal collision. DTC Logi ...B1212, B1213, B1214 satellite sensor RH
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSU ...Other materials:
Vehicle information
Identification information
Japan production models
JAPAN PRODUCTION MODELS : Model Variation
Model variation code (Prefix and suffix designations)
JAPAN PRODUCTION MODELS : Information About Identification or Model Code
IDENTIFICATION NUMBER
1. Air conditioner specification label
2. Ve ...
Inspection
OIL LEAKAGE
Check transfer surrounding area (oil seal, drain plug, filler plug, and
transfer case etc.) for oil leakage.
OIL LEVEL
1. Remove filler plug (1) and gasket. Then check that oil is filled up
from mounting hole for the filler plug.
Vehicle front
CAUTION:
Never start engine while ...
Before starting the engine
• Make sure the area around the vehicle is clear.
• Check fluid levels such as engine oil, coolant, brake fluid, and window washer
fluid as frequently as
possible, or at least whenever you refuel.
• Check that all windows and lights are clean.
• Visually inspect tires for their appearance and ...