Nissan Juke Service and Repair Manual : Auto door lock operation does not operate

Nissan Juke Service and Repair Manual / Door & Lock type 4 / Symptom diagnosis / Auto door lock operation does not operate

Diagnosis Procedure

1.CHECK “AUTO LOCK SET” SETTING WITH CONSULT-III

1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III.

2. Select “AUTO LOCK SET” in “WORK SUPPORT” mode.

3. Check “AUTO LOCK SET” in “WORK SUPPORT”.

Refer to DLK-502, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT) (Without Super Lock)".

Is the inspection result normal? YES >> GO TO 2.

NO >> Set “AUTO LOCK SET” in “WORK SUPPORT”.

2.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    P range interlock door lock/unlock function does not operate
    Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mod ...

    Unlock link function does not operate
    Diagnosis Procedure 1.REPLACE BCM • Replace BCM. Refer to BCS-161, "Removal and Installation". • Confirm the operation after replacement. Is the result normal? YES >> INSPECTION ...

    Other materials:

    P0643 sensor power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

    Basic inspection
    DIAGNOSIS AND REPAIR WORK FLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW THE CUSTOMER FOR THE SYMPTOM Interview the customer for the symptom (the condition and the environment when the incident/malfunction occurs). >> GO TO 2. 2.CHECK SYMPTOM Check the symptom from ...

    B2628 outside antenna
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Disconnect outside key antenna (rear bumper) connector. 2. Perform “INTELLIGENT KEY” Self Diagnostic Result. Is outside key antenna DTC detected? YES >> Refer to DLK-65, "Diagnosis ...