Nissan Juke Service and Repair Manual : Assembly and Installation

• Use torque wrench to tighten bolts or nuts to specification.

• When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, do exactly as specified.

• Replace with new gasket, packing, oil seal or O-ring.

• Thoroughly wash, clean, and air-blow each part. Carefully check engine oil or engine coolant passages for any restriction and blockage.

• Avoid damaging sliding or mating surfaces. Completely remove foreign materials such as cloth lint or dust. Before assembly, oil sliding surfaces well.

• Release air within route when refilling after draining engine coolant.

• After repairing, start the engine and increase engine speed to check engine coolant, fuel, engine oil, and exhaust gases for leakage.

    Inspection, Repair and Replacement
    Before repairing or replacing, thoroughly inspect parts. Inspect new replacement parts in the same way, and replace if necessary. ...

    Parts Requiring Angle Tightening
    • Use the angle wrench [SST: KV10112100] for the final tightening of the following engine parts: - Camshaft sprocket (INT) bolt - Cylinder head bolts - Main bearing cap bolts - Connecting rod ca ...

    Other materials:

    ESP warning lamp
    Component Function Check 1.CHECK ESP WARNING LAMP FUNCTION Check that ESP warning lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON. CAUTION: Never start engine. Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to d ...

    P17B7 high clutch solenoid
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...

    Event Data Recorders (EDR)
    This vehicle is equipped with an Event Data Recorder (EDR). The main purpose of an EDR is to record, in certain crash or near crash-like situations, such as an air bag deployment or hitting a road obstacle, data that will assist in understanding how a vehicle’s systems performed. The EDR is d ...