Nissan Juke Service and Repair Manual : Assembly and Installation

• Use torque wrench to tighten bolts or nuts to specification.

• When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, do exactly as specified.

• Replace with new gasket, packing, oil seal or O-ring.

• Thoroughly wash, clean, and air-blow each part. Carefully check engine oil or engine coolant passages for any restriction and blockage.

• Avoid damaging sliding or mating surfaces. Completely remove foreign materials such as cloth lint or dust.

Before assembly, oil sliding surfaces well.

• Release air within route when refilling after draining engine coolant.

• After repairing, start the engine and increase engine speed to check engine coolant, fuel, engine oil, and exhaust gases for leakage.

    Inspection, Repair and Replacement
    Before repairing or replacing, thoroughly inspect parts. Inspect new replacement parts in the same way, and replace if necessary. ...

    Parts Requiring Angle Tightening
    • Use the angle wrench [SST: KV10112100 (BT8653-A)] for the final tightening of the following engine parts: - Camshaft sprocket (INT) bolt - Cylinder head bolts - Main bearing cap bolts - Connec ...

    Other materials:

    P0380 glow rela
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0380 is displayed with DTC P0560 or P0657, first perform trouble diagnosis for DTC P0560 or P0657. Refer to EC-963, "DTC Logic" (DTC P0560) or EC-976, "DTC Logic" (DTC P0657). Diagnosis Procedure 1.CHECK GLOW RELAY POWER SUP ...

    Engine maintenance (HR16DE)
    Drive belt DRIVE BELT : Checking • Inspection should be done only when engine is cold or over 30 minutes after the engine is stopped. 1 : Alternator 2 : Water pump 3 : Crankshaft pulley 4 : A/C compressor 5 : Idler pulley 6 : Drive belt • Visually check belts for wear, damage, and cracks ...

    Coil spring
    Exploded View 1. Upper rubber seat 2. Coil spring 3. Lower rubber seat 4. Suspension arm : Vehicle front Removal and Installation REMOVAL 1. Remove tires. Refer to WT-7, "Removal and Installation". 2. Remove wheel sensor and sensor harness. Refer to BRC-86, "REAR WHEEL SE ...