Nissan Juke Service and Repair Manual : Antenna base
Exploded View
1. Antenna rod
2. Antenna base
: N·m (kg-m, in-lb)
Removal and Installation
REMOVAL
1. Remove headlining. Refer to INT-26, "Exploded View".
2. Disconnect antenna feeder connector.
3. Remove nut to remove antenna base.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
If the antenna base mounting nut is tightened looser than the specified torque,
then this will lower the
sensitivity of the antenna. On the other hand, if the nut is tightened tighter
than the specified torque,
then this will deform the roof panel.
Rear door speaker
Removal and Installation REMOVAL 1. Remove rear door finisher. Refer to INT-16, "Exploded View". 2. Remove rear door speaker screws, then disconnect rear door speaker connector and remo ...GPS antenna
Feeder Layout Removal and Installation REMOVAL 1. Remove instrument panel. Refer to IP-12, "Exploded View". 2. Remove antenna feeder clip, then remove GPS antenna screw and remove GPS ...Other materials:
B2109 steering lock relay
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2109 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
PCS-30, "DTC Logic".
• When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1
second), the DTC B2109 may be
detected.
DTC ...
Vehicle does not enter 4WD mode
Description
Vehicle does not enter 4-wheel drive mode even though 4WD warning lamp turned
to OFF.
Diagnosis Procedure
1.CHECK 4WD WARNING LAMP
Turn the ignition switch ON.
Does 4WD warning lamp turn ON?
YES >> GO TO 2.
NO >> Proceed to diagnosis procedure. Refer to DLN-80, & ...
B2110 shift position/clutch interlock switch
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC B2110 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to PCS-
30, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Shift selector lever to the P position.
2. Turn ign ...