Nissan Juke Service and Repair Manual : Ambient sensor
Removal and Installation
REMOVAL
1. Remove bumper fascia assembly. Refer to EXT-13, "Removal and Installation".
2. Disengage fixing pawl, and then remove ambient sensor (1) from air guide RH.
: Pawl
3. Disconnect ambient sensor connector (2), and then remove ambient sensor.
INSTALLATION
Install in the reverse order of removal.
A/C auto AMP
Removal and Installation REMOVAL 1. Remove audio unit. Refer to AV-38, "Removal and Installation". 2. Remove inside key antenna (instrument center). Refer to DLK-188, "INSTRUMENT C ...In-vehicle sensor
Removal and Installation REMOVAL 1. Remove instrument lower panel (LH/RH). Refer to IP-13, "Removal and Installation". 2. Remove fixing screw, and then remove in-vehicle sensor from ins ...Other materials:
Rear-facing child restraint installation using the seat belts
WARNING
The three-point seat belt with Automatic Locking Retractor (ALR) must be used
when installing a child restraint.
Failure to use the ALR mode will result in the child restraint not being properly
secured. The restraint could tip over or be loose and cause injury to a child in
a sudd ...
P17B5 low brake solenoid
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
1. S ...
Auto door lock operation does not operate
Diagnosis Procedure
1.CHECK “AUTO LOCK SET” SETTING WITH CONSULT-III
1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III.
2. Select “AUTO LOCK SET” in “WORK SUPPORT” mode.
3. Check “AUTO LOCK SET” in “WORK SUPPORT”.
Refer to DLK-372, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MU ...