Nissan Juke Service and Repair Manual : Ambient sensor
Removal and Installation
REMOVAL
1. Remove bumper fascia assembly. Refer to EXT-13, "Removal and Installation".
2. Disengage fixing pawl, and then remove ambient sensor (1) from air guide RH.
: Pawl
3. Disconnect ambient sensor connector (2), and then remove ambient sensor.
INSTALLATION Install in the reverse order of removal.
A/C auto AMP.
Removal and Installation REMOVAL 1. Remove audio unit. Refer to AV-38, "Removal and Installation". 2. Remove inside key antenna (instrument center). Refer to DLK-188, "INSTRUMENT C ...In-vehicle sensor
Removal and Installation REMOVAL 1. Remove instrument lower panel (LH/RH). Refer to IP-13, "Removal and Installation". 2. Remove fixing screw, and then remove in-vehicle sensor from ins ...Other materials:
Door does not lock/unlock with driver side door lock
knob or door key cylinder
Diagnosis Procedure
1.CHECK POWER DOOR LOCK OPERATION
Check power door lock operation.
Does door lock/unlock with door lock and unlock switch?
YES >> GO TO 2.
NO >> Refer to DLK-254, "Component Function Check".
2.CHECK UNLOCK SENSOR
Check unlock sensor.
Refer to ...
B2621 inside antenna
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “INSIDE ANT DIAGNOSIS” in “WORK SUPPORT” mode.
3. Perform inside key antenna (“INSIDE ANT DIAGNOSIS”) on “WORK SUPPORT” of
“INTELL ...
Lubricant
Description
MAINTENANCE OF LUBRICANT LEVEL
The compressor lubricant is circulating in the system together with the
refrigerant. It is necessary to fill compressor
with lubricant when replacing A/C system parts or when a large amount of
refrigerant leakage is
detected. It is important to alwa ...