Nissan Juke Service and Repair Manual : Air cleaner filter

Exploded View

1. Hose clamp


1. Hose clamp
2. PCV hose
3. Hose clamp
4. Air cleaner filter
5. Air cleaner filter case 6. Grommet
7. Inlet Air duct (lower) 8. Grommet
9. Inlet Air duct (upper) 10. Bracket
11. Air cleaner case
12. O-ring
13. Mass air flow sensor 14. Air duct

A. To electric throttle control actuator B. To rocker cover

disassembly.: Always replace after every
disassembly.

Removal and Installation: N·m (kg-m, in-lb)


Removal and Installation

REMOVAL

1. Remove the assembly consisting of element case, air cleaner case, and inlet air duct (upper).

2. Remove the air cleaner filter case.

3. Remove the air cleaner filter (2) from the air cleaner case (1).

INSTALLATION


INSTALLATION

Note the following, and install in the reverse order of removal.

• Check by the feel and the sound that both pawls of the air cleaner case are securely fastened to the element case.

    Drive belt
    Checking • Inspection should be done only when engine is cold or over 30 minutes after the engine is stopped. 1 : Alternator 2 : Water pump 3 : Crankshaft pulley 4 : A/C compressor 5 : Idler p ...

    Spark plug
    Removal and Installation REMOVAL 1. Remove ignition coil. Refer to EM-178, "Exploded View". 2. Remove spark plug with a spark plug wrench (commercial service tool). a : 14 mm (0.55 in) ...

    Other materials:

    U1405 engine torque signal
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM ECM SELF-DIAGNOSIS Using CONSULT-III, check the “self diagnosis result” of “ENGINE” and repair or replace any malfunctioning parts. >> • Refer to EC-108, "DTC Index". (MR16DDT) • Refer to EC-522, "DTC Index ...

    System
    Relay control system RELAY CONTROL SYSTEM : System Diagram *1: Except for MR16DDT engine models *2: For MR16DDT engine models RELAY CONTROL SYSTEM : System Description IPDM E/R activates the internal control circuit to perform the relay ON-OFF control according to the input signals from va ...

    Magnet clutch
    Component Function Check 1.CHECK MAGNET CLUTCH OPERATION Perform auto active test of IPDM E/R. Refer to PCS-12, "Diagnosis Description" (with Intelligent Key) or PCS- 43, "Diagnosis Description" (without Intelligent Key). Does it operate normally? YES >> INSPECTION ...