Nissan Juke Service and Repair Manual : Air cleaner and air duct
Exploded View
1. Turbocharger air inlet pipe
2. Clamp
3. Air duct (suction)
4. Air mass flow sensor
5. O-ring
6. Air duct (inlet)
7. Grommet
8. Air cleaner case
9. Air cleaner filter
10. Cover
11. Holder
A. : To turbocharger
: Vehicle front
: N·m (kg-m, in-lb)
: Always replace after every
disassembly.
Removal and Installation
REMOVAL
1. Remove resonator.
2. Remove air duct (inlet).
3. Remove battery. Refer to PG-124, "Exploded View".
4. Remove air duct (suction).
5. Disconnect mass air flow sensor harness connector.
6. Remove air cleaner case by sliding the air cleaner case frontward.
CAUTION:
Slide the air cleaner case carefully so as not to damage it on the air cleaner
case and harness
bracket.
INSTALLATION
• Install in the reverse order of removal.
Charge air cooler
Exploded View 1. Air inlet hose 2. Clamp 3. Air inlet tube 4. Air inlet hose 5. Charge air cooler 6. Air inlet hose 7. Air inlet tube 8. Turbocharger 9. Air inlet tube assembly A. 1 ...Other materials:
Outside key antenna
Driver side
DRIVER SIDE : Removal and Installation
REMOVAL
Remove the driver side outside handle. Refer to DLK-176, "OUTSIDE HANDLE :
Removal and Installation".
INSTALLATION
Install in the reverse order of removal.
Passenger side
PASSENGER SIDE : Removal and Installation
REMOVA ...
Diagnosis and repair work flow
Work Flow
OVERALL SEQUENCE
Reference 1··· Refer to AV-33, "MODELS WITH USB CONNECTION FUNCTION : Symptom
Table" (with USB
connection function) or AV-35, "MODELS WITHOUT USB CONNECTION FUNCTION : Symptom
Table" (without
USB connection function).
DETAILED FLOW
1.CHECK ...
P181D engine torque signal
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With ...