Nissan Juke Service and Repair Manual : Air breather hose
Removal and Installation
REMOVAL
1. Remove clip from bracket.
2. Remove air breather hose from transaxle assembly.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
• Check that air breather hose is not collapsed or blocked due to folding or
bending when installed.
• Securely install the clip to the bracket.
• Be sure to insert it fully until its end reaches the stop when inserting air breather hose (1) to transaxle tube (A).
• Install air breather hose to transaxle tube so that the paint mark (B) is facing frontward.
TCM
Exploded View 1. Bracket 2. TCM :Vehicle front : N·m (kg-m, in-lb) Removal and Installation CAUTION: When replacing TCM, note the “CVTF DETERIORATION DATE” value displayed on CONSULT-III “ ...G sensor
Exploded View 1. Bracket 2. G sensor : Vehicle front : N·m (kg-m, ft-lb) : N·m (kg-m, in-lb) Removal and Installation CAUTION: • Never drop or strike G sensor, because it has little toleran ...Other materials:
Ignition coil, spark plug and rocker cover
Exploded View
1. Rocker cover protector
2. O-ring
3. PCV control valve
4. PCV hose
5. Clamp
6. Rocker cover gasket
7. Rocker cover
8. Clamp
9. PCV hose
10. Oil filler cap
11. Spark plug
12. Ignition coil
A. To air duct assembly
B.Tightening must be done following
the instal ...
Normal operating condition
Description
FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED)
If the engine speed is above 1,800 rpm under no load (for example, the
selector lever position is neutral and
engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact
time when the fuel is cut off varies
b ...
P0402 EGR volume control valve
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK GROUND CONNECTIONS
1. Turn ignition switch OFF.
2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit
Inspection".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or ...