Nissan Juke Service and Repair Manual : Air breather hose

Removal and Installation

REMOVAL

1. Remove air cleaner case. Refer to EM-26, "Removal and Installation".

2. Remove clip from bracket.

3. Remove air breather hose from transaxle assembly.

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
Check air breather hose not collapsed or blocked due to folding or bending when installed.

• Install air breather hose to air breather tube so that the paint mark (A) faces upward. Also insert hose to the bend of air breather tube.

G sensor


    TCM
    Exploded View 1. Bracket 2. TCM :Vehicle front : N·m (kg-m, in-lb) Removal and Installation NOTE: When replacing TCM and transaxle assembly as a set, replace transaxle assembly first and ...

    G sensor
    Exploded View 1. G sensor : Vehicle front : N·m (kg-m, in-lb) Removal and Installation CAUTION: • Never drop or strike G sensor, because it has little tolerance for impact. • Never use a ...

    Other materials:

    ECU diagnosis information
    ECM Reference Value TERMINAL LAYOUT PHYSICAL VALUES NOTE: • ECM is located in the engine room left side near battery. • When disconnecting ECM harness connector (1), loosen (B) it with levers as far as they will go as shown in the figure. 2 : ECM A : Fasten • Pulse signal is measur ...

    Windshield wiper and washer switch
    WARNING In freezing temperatures the washer solution may freeze on the windshield and obscure your vision which may lead to an accident. Warm windshield with the defroster before you wash the windshield. CAUTION • Do not operate the washer continuously for more than 30 seconds. • Do not ...

    S mode switch
    Component Function Check 1.CHECK S MODE INDICATOR FUNCTION Check S mode indicator turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection results normal? YES >> GO TO 2. NO >> Go to TM-469, "Diagnosis Procedure". 2.CHECK S MODE SWITCH FUNCT ...