Nissan Juke Service and Repair Manual : Air breather hose

MR16DDT : Exploded View

1. Clip


1. Clip
2. Air breather hose
3. 2 way connector

MR16DDT : Removal and Installation

REMOVAL

1. Remove air cleaner case. Refer to EM-26, "Removal and Installation".

2. Remove clips (1).

3. Remove air breather hose from the 2 way connector.: Vehicle front


3. Remove air breather hose from the 2 way connector.

CAUTION:
When removing air breather hose, be sure to hold 2 way connector securely.

INSTALLATION


INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
• Install air breather hose, preventing crush and clogging caused by bending.

• Insert the allowance of air breather hose to the spool of the 2 way connector.

• Install air breather hose to the 2 way connector with the paint mark faced forward of the vehicle.

• Securely engage the clips in the mounting hole.

K9K : Exploded View

1. Clip


1. Clip
2. Air breather hose
3. 2 way connector

K9K : Removal and Installation

REMOVAL

1. Remove clips (1).

2. Remove air breather hose from the 2 way connector.: Vehicle front


2. Remove air breather hose from the 2 way connector.

CAUTION:
When removing air breather hose, be sure to hold 2 way connector securely.

INSTALLATION


INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
• Install air breather hose, preventing crush and clogging caused by bending.

• Insert the allowance of air breather hose to the spool of the 2 way connector.

• Install air breather hose to the 2 way connector with the paint mark faced forward of the vehicle.

• Securely engage the clips in the mounting hole.

    Control linkage
    Exploded View 1. Bracket 2. Shifter cable 3. Selector lever 4. Shifter lever A 5. Tapping bolt 6. Cable mounting bracket 7. Selector cable 8. Grommet 9. M/T shift selector assembly 1 ...

    Unit removal and installation
    Transaxle assembly MR16DDT : Exploded View 1. Transaxle assembly : Refer to "INSTALLATION" in TM-84, "MR16DDT : Removal and Installation" for the locations and tightening ...

    Other materials:

    Locking with key
    The power door lock system allows you to lock or unlock all doors simultaneously. •  Turning the driver’s door key cylinder to the front of the vehicle1 will lock all doors and the lift gate. • Turning the driver’s door key cylinder once to the rear of the vehicle2 will unlock the drive ...

    Structure and operation
    Transaxle : Cross-Sectional View 1. Converter housing 2. Oil pump 3. Counter drive gear 4. Control valve 5. Oil pan 6. Primary pulley 7. Steel belt 8. Secondary pulley 9. Planetary gear (auxiliary gearbox) 10. Side cover 11. Transaxle case 12. Differential case 13. Final gear ...

    P1651 starter motor relay
    Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. Models with no Intelligent Key System transmit a control signal directly to IPDM E/R. On the other hand, models with the Intelligent Key System transmit a control signal to IPDM E/R by w ...