Nissan Juke Service and Repair Manual : Air breather hose

Exploded View

1. Clip


1. Clip
2. Air breather hose
3. 2 way connector

Removal and Installation

REMOVAL

1. Remove clips (1).

2. Remove air breather hose from the 2 way connector.: Vehicle front


2. Remove air breather hose from the 2 way connector.

CAUTION:
When removing air breather hose, be sure to hold 2 way connector securely.

INSTALLATION


INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
• Install air breather hose, preventing crush and clogging caused by bending.

• Insert the allowance of air breather hose to the spool of the 2 way connector.

• Install air breather hose to the 2 way connector with the paint mark faced forward of the vehicle.

• Securely engage the clips in the mounting hole.

    Control linkage
    Exploded View 1. Bracket 2. Selector cable 3. Shifter lever A 4. Selector lever 5. Cable mounting bracket 6. Tapping bolt 7. Shifter cable 8. Grommet 9. M/T shift selector assembly 1 ...

    5TH main gear assembly
    Removal and Installation REMOVAL 1. Shift the shifter lever to the 3rd gear position. 2. Disconnect the shifter cable and the selector cable from shifter lever A and selector lever. Refer to TM-2 ...

    Other materials:

    Additional service when replacing ECM
    Description When replacing ECM, this procedure must be performed. Work Procedure 1.PRECONDITIONING • Connect a CONSULT-III • Connect a battery charger • Electric load switch is OFF • Wait for the engine to cool [engine coolant temperature < 60?°C (140?°F) and air temperature < 50?°C ( ...

    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
    The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is include ...

    Audio unit
    Removal and Installation REMOVAL 1. Remove cluster lid C. Refer to IP-12, "Exploded View". 2. Remove audio unit screws. 3. Disconnect audio unit connectors to remove audio unit and brackets as a single unit. 4. Remove brackets screws to remove audio unit. INSTALLATION 1. Install ...