Nissan Juke Service and Repair Manual : Additional service when replacing ABS actuator and electric unit (control unit)
Description
When replaced the ABS actuator and electric unit (control unit), Perform decel G sensor calibration. Refer to BRC-149, "Work Procedure".
Diagnosis and repair work flow
Work Flow DETAILED FLOW 1.INTERVIEW FROM THE CUSTOMER Clarify customer complaints before inspection. First of all, perform an interview utilizing BRC-146, "Diagnostic Work Sheet" and r ...Adjustment of steering angle sensor neutral position
Description Always adjust the neutral position of steering angle sensor before driving when the following operation is performed. Work Procedure ADJUST THE NEUTRAL POSITION OF STEERING ANGLE SE ...Other materials:
HR16DE : Exploded View
REMOVAL
1. Cylinder block
2. “B” terminal harness
3. “S” terminal harness
4. Starter motor
: Vehicle front
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
DISASSEMBLY
Type: M000T32172ZE
1. “M” terminal nut
2. Magnetic switch assembly
3. Adjusting plate
4. Metal FR
5. Gear case
6. Yo ...
Liquid Gasket
REMOVAL OF LIQUID GASKET
• After removing mounting nuts and bolts, separate the mating surface
using the seal cutter [SST: KV10111100] (A) and remove old
liquid gasket sealing.
CAUTION:
Be careful not to damage the mating surfaces.
• Tap the seal cutter [SST: KV10111100] to insert it (B), an ...
Radiator : Inspection
Check radiator for mud or clogging. If necessary, clean radiator as follows.
CAUTION:
• Be careful not to bend or damage radiator fins.
• When radiator is cleaned without removal, remove all surrounding parts such as
radiator cooling fan
assembly and horns. Then tape harness and harness conn ...