Nissan Juke Service and Repair Manual : A/C control
Exploded View
1. Intake door cable
2. Air mix door cable
3. Mode door cable
4. A/C control
5. Intake door lever knob
A. To intake door link B. To air mix door link C. To mode door link
Removal and Installation
REMOVAL
1. Remove A/C finisher. Refer to IP-13, "Removal and Installation".
2. Remove A/C control fixing screws (A) and fixing pawls, and then remove A/C control.
: Pawl
3. Disconnect door cable and harness connector from A/C control.
INSTALLATION
Install in the reverse order of removal.
Thermo control amplifier
Removal and Installation REMOVAL 1. Remove evaporator. • Refer to HA-55, "EVAPORATOR : Removal and Installation". (HR16DE) • Refer to HA-115, "EVAPORATOR : Removal and Installatio ...Other materials:
P0222, P0223 TP sensor
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0222 or P0223 is displayed with DTC P0643 ,first perform the trouble
diagnosis for DTC P0643.
Refer to EC-274, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, alw ...
Fuel level sensor unit
Exploded View
1. Lock ring
2. Fuel level sensor unit
3. Seal packing
A. To fuel tank
: Always replace after every
disassembly
Removal and Installation
WARNING:
Read “General Precautions” when working on the fuel system. Refer to FL-45,
"General Precautions".
REMOVAL
1. Ch ...
Precaution
Service Notice or Precautions for Rear Final Drive
• Check for the correct installation status prior to removal or disassembly.
If matching marks are required, be
certain they do not interfere with the function of the parts when applied.
• Overhaul should be done in a clean work area, it is pre ...