Nissan Juke Service and Repair Manual : A/C control
Exploded View
1. Intake door cable
2. Mode door cable
3. A/C control
4. Air mix door cable
5. Intake door lever knob
A. To mode door link
B. To intake door link
C. To air mix door link
Removal and Installation
REMOVAL
1. Remove A/C finisher. Refer to IP-13, "Removal and Installation".
2. Remove A/C control fixing screws (A) and fixing pawls, and then remove A/C control.
Pawl
3. Disconnect door cable and harness connector from A/C control.
INSTALLATION
Install in the reverse order of removal.
Thermo control amplifier
Removal and Installation REMOVAL 1. Remove evaporator. Refer to HA-115, "EVAPORATOR : Removal and Installation". 2. Remove thermo control amp. from evaporator. INSTALLATION Note the ...Other materials:
Door does not lock/unlock with driver side door lock
knob or door key cylinder
Diagnosis Procedure
1.CHECK POWER DOOR LOCK OPERATION
Check power door lock operation.
Does door lock/unlock with door lock and unlock switch?
YES >> GO TO 2.
NO >> Go to DLK-534, "ALL DOOR : Diagnosis Procedure".
2.CHECK UNLOCK SENSOR
Check unlock sensor.
Refer ...
Brake booster
Exploded View
2WD
1. Master cylinder assembly
2. Vacuum pipe
3. Brake booster
4. Lock nut
5. Clevis
6. Gasket
7. Spacer
: N·m (kg-m, ft-lb)
4WD
1. Master cylinder assembly
2. Brake booster
3. Lock nut
4. Clevis
5. Gasket
6. Spacer
: N·m (kg-m, ft-lb)
Removal and install ...
Lower link
Exploded View
1. Rear suspension member
2. Adjusting bolt
3. Upper link
4. Eccentric disk
5. Lower link
6. Suspension arm bracket
7. Suspension arm
: Vehicle front
: Always replace after every
disassembly.
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVAL
1. Remove tires. Ref ...