Controller

Removal and Installation REMOVAL Remove multi display unit. Refer to IP-13, "Removal and Installation". INSTALLATION Install in the reverse order of removal. ...

Ambient sensor

Removal and Installation REMOVAL 1. Remove bumper fascia assembly. Refer to EXT-13, "Removal and Installation". 2. Disengage fixing pawl, and then remove ambient sensor (1) from air gu ...

Other materials:

Difference between predictive and actual distances
Backing up on a steep uphill When backing up the vehicle up a hill, the distance guide lines and the vehicle width guide lines are shown closer than the actual distance. For example, the display shows 3 ft (1 m) to the placeA , but the actual 3 ft (1 m) distance on the hill is the placeB . N ...

Diagnosis system (IPDM E/R) (without intelligent key system)
Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. • Oil pressure warning lamp (only for K9K engine models) • Rear window defogger • Front wiper motor • Parking lamp • License p ...

5TH injector
Exploded View 1. 5th injector retaining bracket 2. 5th injector bolt 3. 5th injector 4. Injector seal 5. Diesel injector cooler 6. Gasket 7. Turbocharger outlet duct : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVAL CAUTION: • Be sure ...