Nissan Juke Service and Repair Manual : 5TH injector
Exploded View
1. 5th injector retaining bracket
2. 5th injector bolt
3. 5th injector
4. Injector seal
5. Diesel injector cooler
6. Gasket
7. Turbocharger outlet duct
: N·m (kg-m, ft-lb)
: Always replace after every
disassembly.
Removal and Installation
REMOVAL
CAUTION:
• Be sure to read "Precautions for diesel equipment". Refer to EM-263,
"Precaution for Diesel Equipment".
• Make preparations for coolant outflow.
1. Remove air cleaner case. Refer to EM-280, "Exploded View".
2. Disconnect quick connector(1) and harness connector (2).
CAUTION:
• Be careful not to damage the connector.
• Be sure to read "Precautions for diesel equipment". Refer to EM-263, "Precaution for Diesel Equipment"
3. Remove the following parts from the upper side of the engine.
• Remove fixing bolt (A) of 5th injector retaining bracket (1) • Remove 5th injector retaining bracket (1).
4. Remove the 5th injector (2) and injector seal. Refer to EM-296, "Exploded View"
INSTALLATION
1. Clean the 5th injector: • Immerse the 5th injector in a container of diesel.
• Wipe using clean cloth.
CAUTION:
Never clean the 5th injector with:
• A wire brush,
• An emery cloth,
• An ultrasonic cleaner.
2. Always replace the injector seal.
3. Install the 5th injector, injector seal and 5th injector retaining bracket assembly.
CAUTION:
Before tightening the 5th injector retaining bracket, check that the 5th
injector is correctly positioned
in relation to the bracket.
4. Install the other parts in the reverse order of the removal.
Injection tube and fuel injector
Exploded View 1. Spill hose 2. Injection tube 3. Fuel injector 4. Heat protection washer 5. Fuel injector bracket 6. Fuel injector bracket spacer 7. Fuel rail stud bolt 8. Fuel rail 9 ...High pressure supply pump
Exploded View 1. High pressure supply pump protector 2. High pressure supply pump : N·m (kg-m, ft-lb) Removal and Installation REMOVAL CAUTION: • Be sure to read “Precautions for Diesel Equi ...Other materials:
Front disc brake
Brake pad : Inspection and Adjustment
INSPECTION
Check brake pad wear thickness from an inspection hole on cylinder
body. Check using a scale if necessary.
Wear thickness : Refer to BR-71, "Front Disc Brake".
ADJUSTMENT
Burnish contact surfaces between disc rotor and brake pads acc ...
P1612 chain of ECM-IMMU
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC P1612 is displayed with DTC U1000 (for BCM), first perform the trouble
diagnosis for DTC U1000.
Refer to BCS-83, "DTC Logic".
• If DTC P1612 is displayed with DTC U1010 (for BCM), first perform the trouble
diagnosis for DTC U1010.
...
Back door opener system
System Diagram
System Description
BACK DOOR OPENER OPERATION
When back door opener switch is pressed, BCM operates back door opener
actuator.
NOTE:
Back door opener actuator is not for locking the back door. The function is only
to open the back door.
OPERATION CONDITION
If the foll ...