Nissan Juke Service and Repair Manual : 4WD warning lamp does not turn on
Description
4WD warning lamp does not turn ON when the ignition switch is turned to ON.
Diagnosis Procedure
1.CHECK 4WD WARNING LAMP
Perform the trouble diagnosis for 4WD warning lamp. Refer to DLN-80, "Diagnosis Procedure".
Is the inspection result normal? YES >> Check each harness connector pin terminal for malfunction or disconnection.
NO >> Repair or replace the error-detected parts.
4WD warning lamp does not turn off
Description 4WD warning lamp does not turn OFF several seconds after the engine started. Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS With CONSULT-III Perform self-diagnosis for “ALL MODE AWD/4WD ...Other materials:
LAN System can system (type 10)
DTC/CIRCUIT DIAGNOSIS
Main line between IPDM-E and DLC circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (connector s ...
C1144 incomplete steering angle sensor adjustment
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...
Horn function
Component Function Check
1.CHECK FUNCTION 1
1. Disconnect vehicle security horn relay.
2. Perform “VEHICLE SECURITY HORN” in “ACTIVE TEST” mode of “THEFT ALM” of “BCM”
using CONSULT-
III.
3. Check the horn operation.
Is the operation normal?
YES >> GO TO 2.
NO >> Go to SEC- ...